This cycle, which tends to coincide with extended periods of industrialization and modernization, helps in telling a story of human development. Also being the 2004 was a 4 door extended cab, the seats do not slide forwards on their own when you release the seat latch.Since the beginning of the Industrial Revolution, the world has seen its population and the need for natural resources boom.Īs more people and wealth translate into the demand for global goods, the prices of commodities-such as energy, agriculture, livestock, and metals-have often followed in sync. I had to swap the seat belt receiver from his old seats to the new ones, that was it (and remove the seat belt pretensioners). Everything lines up perfect, exact same seat tracks. It looked awful close to fitting so I did some measuring. The seat tracks are welded to the 2004 seats so there was no swapping them. Tonight I just installed a set of bucket seats out of a 2004 ranger extended cab into my friends 1994 extended cab. The 2000 seats had all the holes in them already to bolt up to my 1997 tracks, they just weren’t threaded yet. I had to swap the seat tracks from my original seats onto the 2000 seats. “Ok…I have installed a 60/40 bench from a 2000 Ford Ranger extended cab into my 1997 regular cab. 2000 era Ford Rangers have tracks that unbolt from the seat pan and the seat pans on the passenger and the drivers seats are the same. Two passenger side seats makes one set of bucket seats.Ģ002 Ford Explorer seat and console in 1996 Ford Ranger If all else fails use two Passenger Seats from two Rangers with the 60/40 Bench seats. If you want memory seats, grab the switch from the Explorer door, and connect the wires to the same colors on the switch.ĭO NOT TOUCH any wiring associated with the YELLOW connector.
Red/Black – +12V in run position (join with grey/yellow)Ģx Green/Yellow +12V fused 30amp (join with black/white and blue/white) I suggest you tap into a large gauge wire under the dash, and add your own 30 amp fuse.īlue/White – +12v fused 30amp (join with black/white wire)īlack/White (large gauge) – +12v fused 30amp Explorer seats need the 60/40 or bucket seat tracks from a regular cab Ranger to work.Ģ002 and newer Ford Explorer seats are wider, and will not bolts up to the Ranger tracks.
The Explorer seat brackets should be held on by (4) 10mm bolts.Įxplorer seat tracks only work on extended cab Rangers. Here is another set of Explorer buckets mounted in an extended cab Ranger using the Ranger’s 60/40 split bench seat brackets.
0 kommentar(er)
